25 YEAR OLD LOADING DOCK QUICK REHAB WITH ECOGUARD PORE FILLER

  • 25 Year Old Concrete
  • After Titanium MB # 30-40 (2)
  • After Titanium MB # 30-40
  • After Shark # 100
  • Water Gloss # 200 - 400 - 800
  • Water Gloss # 200 - 400 - 800 (2)
  • Water Gloss # 200 - 400 - 800 (3)
  • End Result
  • 25 Year Old Concrete
  • After Titanium MB # 30-40 (2)
  • After Titanium MB # 30-40
  • After Shark # 100
  • Water Gloss # 200 - 400 - 800
  • Water Gloss # 200 - 400 - 800 (2)
  • Water Gloss # 200 - 400 - 800 (3)
  • End Result
ECOGUARD™ Pore Filler
$110.00
STEP 1
FIRST GRINDING STEP (Choice of the Following):
  • MB Titanium # 30/40
  • Speed Titanium # 30/40
  • Hyper Grind
  • Hyper Cut – PCD / PKD
Attention:
On soft floors or floors with deep scratches: Grind out the scratches with Shark #30 in Dry
STEP 2
Apply the Pore and Crack Filler with a pumpspray system in the following mixture:
  • slight pores:
  • big pores:
  • extreme big pores up to 10 mm dm.:
  • …… plus deep cracks
1:9
1:5
1:2 to 1:3
1:2 to 1:3
Drive over cross with SHARK # 100 on the applied floor.
It makes immediatly a sludge, pasty mass.
It is important, that the pasty mass will not grind to a dry condition.
Incorporate the ground evenly.
Attention : Clean the machine after the work.
STEP 3
The mass has to dry now.
Depending on the weather:
Summer – very hot :
Spring /Autumn – cold and wet :
winter :
2 – 3 hours
6 – 9 hours
12 – 16 hours
Important features :
  • Make sure that the floor is complete drying.
  • Dark moist points in the floor suggest that the deep pores in the floor has not dried out.
STEP 4
When can I start with the next ??
  • Dark wet spots or wet cracks in the filler suggest that the deep pores or cracks in the ground are not yet dried up.
  • If possible, keep the room temperature stable.
  • Too early start to the next grinding Step causes that the filled pores will worked out.
  • If the filling mass are dificult to scatch with a knife, then is the foor ready for the next grinding step.
STEP 5

Removing the surface filler:
The flooring is now after he has dried, a gray or beige uniform putty condition !! The right tool for the following types of floor.
  • Floors without aggregate : without grain / CREAM : WATER GLOSS DRY # 100
  • Floors with aggregate : with grain to 6 mm / Salt/Pepper: WATER GLOSS DRY # 100
  • Floor with big aggregate : with grain to 28mm / Aggregate : OCTOPUS DRY # 100


Please remove the putty surface of the flooring.
Drive with the machine over cross with 20 % overlap.
    Result:
  • A pore free floor covering with a satin gloss.
  • Cracks are permanently sealed.
  • Flooring with the best hardening. ( Lithium - Densifier)